90130_ Report This Comment Date: September 05, 2011 04:26AM
Easy, from left; Grease zerk fitting adapter, grease fitting extractor and
threading tap, motorcycle chain pin extractor, and a motorcycle cable
lubricator.
I deserve an ice cold Heineken.
BlahX3 Report This Comment Date: September 05, 2011 04:30AM
#2 is a tap
#3 is set pin remover
#4 is a wire clamp
Mrkim Report This Comment Date: September 05, 2011 04:54AM
If you can tell me what that grease zerk adapter is designed for doin 9er
you're certainly due a frosty cyber Heine
90130_ Report This Comment Date: September 05, 2011 05:09AM
I had to think about it for a bit, but realized I have this same damn tool in
my rollchest drawer with some BMW service tools...
It's a pilot bushing extractor, for removal of bronze bushings from a blind hole
in automotive flywheels. Hydraulic pressure from the grease forces out the
bushing.
Mrkim Report This Comment Date: September 05, 2011 05:22AM
Que the buzzer Johnny!!!
Think a bit more buddy, you're in the ballpark, just poppin flies at the moment
though
I usually use a clutch pilot tool I have with different sized screw on tips for
removin those bushings. I just pack the hole in the butt end of the crank with
grease and then use the alignment tool and a hammer to compact the grease and
pop out the bushing/bearing, as the case may be. Works like a champeen
90130_ Report This Comment Date: September 05, 2011 05:41AM
Hmmm. Ok, come to think of it, the BMW Krautenschlager whathefuck in my tool
box is indeed different. More clues?? I'm gettin' tired and I want my fucking
Heineken. Hey...you are in big D, right? Isn't gettin' late for you?
Mrkim Report This Comment Date: September 05, 2011 05:52AM
Ok, one hint and I'm off to catch a few Zs. The tool is a 2 part assy, the
section furthest from the zerk threads off so you can slip it over the part
before screwin it back together and whippin out the grease gun to work its
magic.
I'll check back with you cats in the mornin and see if anyone else manages to
collect some tasty cyber frosties
SpazzII Report This Comment Date: September 05, 2011 05:31PM
Drug paraphernalia?
Mrkim Report This Comment Date: September 05, 2011 05:47PM
Geez Spaz I dunno what your favorite chemicals might be but then again, if any
of the above would be used in preppin 'em I'd be worried about joinin in the
fun. Instead, I think I'll just stick with my left handers
Mrkim Report This Comment Date: September 17, 2011 01:51AM
Since 9er got close and no one else has taken a swing at it, the far left item
is a 2 piece cable greasing fixture. You unscrew it and slip one 1/2 of it over
the end of a cable housing and then slide the cable and end barrel into the
other 1/2 of the tool then screw the 2 halves together. hit the zerk with a
grease gun and grease if forced through the cable housing. Once you see grease
comin outta the other end of the cable housing you're done.
Greasing a cable actually does a better job of keeping the lubricant in place
than it does to just oil the cable like the tool on the far right is designed
for